100% CPU on X with Console 0 VNC Sles 11 Sp2

[miruten1]

I have 2 new HP BL460C servers 1 G7 1 Gen 8. These are fresh installs of Suse Ent 11 sp2 fully patched. I enable Console 0 access for VNC by this document. http://www.novell.com/support/kb/doc.php?id=7003097 When I connect to Console 0 with VNC the X Process goes to 100% CPU load. If I connect to VNC not console 0 I do not have the high CPU load. If I minimize the window VNC Console 0 and monitor the load form a SSH session load goes back down to 0% on the X process. Once I un minimize the VNC window on console 0 load spikes right back to 100%. It stays at 100% unless the Console 0 VNC is closed or not active.

If I need to supply more details or logs please let me know what is needed and I will provide it. Thanks

[ab1]

Well, I have good news and bad news. The bad news is that you’re not
alone as somebody reported this internally to Novell just about four days
before you did.

The good news is that… you’re not alone, it was reported a few days
ago. If you are in a hurry for a resolution an SR may be the best
approach since I do not know how to troubleshoot this any better than you
have already done, but otherwise I’ll post back results as I find them,
including troubleshooting/workaround steps.

Good luck.